DESIGN AND FABRICATION OF HYDRAULIC PULLER

SYNOPSIS

A hydraulic fluid power system is defined as a means of power transmission   in which relatively in compressible fluid is used as the power transmitting media. The primary purpose of hydraulic system is the transfer of energy from one location to another location and this energy into useful work.

Power clamping is used for holding the job as for as quickly and maintain the constant pressure over the job. Here in our project PULLER is done by hydraulic system. Power clamping system consists of movable jaw, fixed jaw, and hydraulic circuit. This movable jaw is fixed with hydraulic cylinder. When pump is switched on the hydraulic cylinder will moves forward and holds the object very tightly.

The Hydraulic system pressure can be generated in the form of any physical action which result a compression over the Hydraulic system or pneumatic pressure which is developed in the form of air compressing externally can be applied to activate Hydraulic system. There is a constant relation between pressure density, and volume, According to Bernoulli ‘equations.

 

HYDRAULIC PULLER


Share This Post

Recent Articles

10 Responses to “DESIGN AND FABRICATION OF HYDRAULIC PULLER”

  1. vinoth says:

    pls post the full report of this project for my mini project…..soon pls………thanks

  2. jagadeesan says:

    send full details

  3. sheik abdulla says:

    pls snd the full details of this project in my mail id

  4. ARUN says:

    Pls post the full report of this project for my mini project. i am looking forward for your reply

  5. meyyappan says:

    can i get full details of this project pls

  6. sikandar kumar says:

    sir pls sent to me progress report of hydraulic puller(mini project).

  7. jrod says:

    do you have any calculations?

  8. pramod says:

    Sir pls send its full report for our mini project

Leave a Reply

Powered by WordPress · Designed by Theme Junkie